Synthetic marine salt for aquariums with fish & less delicate corals and invertebrates. When setting up new aquariums it is recommended that the first animals are placed no sooner than 10-14 days after filling the aquarium. After dissolving the salt, freshly prepared marine water can be used immediately.
SEA SALT (7,5kg) – marine salt for Soft corals & Fish only tanks
Synthetic marine salt for aquariums with fish and less delicate corals and invertebrates.
When setting up new aquariums it is recommended that the first animals are placed no sooner than 10-14 days after filling the aquarium . After dissolving the salt, freshly prepared marine water can be used immediately.
Parameters of a salt are presented below:
24°C / 75.2°F
Mg – 1200-1300 mg/l
Ca – 360-400 mg/l
K – 300-350 mg/l
dKH – 8,0-9,0
pH – 8,0-8,2
Recommended salinity for different aquarium types:
Macro and micro elements in the water have different levels depending on the salinity:
Instructions for use:
Dissolve the salt in previously prepared demineralised water. Water temperature should be about 24°C (75°F). For salinity of 30 ppt dissolve about 345g (12,16 oz) in 10 liters (2,7 US gal) of water. Stir the solution vigorously for about 15 min. When the salt is fully dissolved and the solution clear the saline water is ready to use.
Keep the salt in a dry and dark place. Once dissolved, use the salt within 5days.
Keep out ofreach of children! Product for aquarium use only! Reef Salt is not suitable for human consumption! Safety data sheet available on request.
How is our Marine Salt product range tested?
We mix our Marine Salt in 1 metric tonne (2204lb) batches, and 3 separate samples per batch are collected during the production stage for testi ng. Each of these samples is dissolved in 15 litres (4US gal) of RO water. Our experienced team of professionals perform
ICP-OES analysis
to verify that the chemical compositi on is within consistent range, and to rule out the presence of unwanted contaminants at the same ti me.
Note:
Even though our salt is thoroughly mixed, not every bucket/box will be identi cal.
The parameters can vary slightly between containers and around a 2-3% variation is acceptable
. This fluctuati on is a result of both physical properties of the mix and the limitations of the processing techniques available. These variations are still smaller than the typical margin for error for popular hobbyist test kits.
